Nibe F1255 Installation Manual page 36

ADJUSTMENT OF CURVE
Climate system
system
flow temperature °C
Min supply temperature
1. Select the climate system (if more than one) for
which the curve is to be changed.
2. Select curve slope and curve offset.
Caution
If you need to adjust "min. flow line temp."
and/or "max flow line temperature", you do this
in other menus.
Settings for "min. flow line temp." in menu
1.9.3.
Settings for "max flow line temperature" in
menu 5.1.2.
Caution
Curve 0 means that
Settings for own curve
1.9.7.
TO READ OFF A HEATING CURVE
Turn the control knob so that the ring on the shaft
1.
with the outdoor temperature is marked.
Press the OK button.
2.
3. Follow the grey line up to the curve and out to the
left to read off the value for the supply temperature
at the selected outdoor temperature.
You can now select to take read outs for different
4.
outdoor temperatures by turning the control knob
to the right or left and read off the corresponding
flow temperature.
5. Press the OK or Back button to exit read off mode.
36 Chapter 6 | Commissioning and adjusting
Curve offset
Curve coefficient
heating curve 1.9.1.1
outdoor temp. °C
Max supply temperature
own curve is used.
are made in menu
NIBE F1255