Accessories
Antenna
This device is fitted with a Male SMA connector. To mount the antenna
(Female SMA connector), align the two connectors and turn the antenna
clockwise until it stops.
•
When installing the antenna, install it by holding the base and
turning.
•
If an external antenna is used, ensure that the 'SWR' is about
1.5:1 or less to avoid damage to the transceiver's transistors.
•
Holding the antenna with your hand or wrapping the outside may
cause subpar operation of the transceiver.
•
Never transmit from the device without an antenna.
Belt Clip
On the back of the radio, above the battery, there are two parallel
screws. Remove the screws and align them so that they go through
the holes on the belt clip as they are screwed back into the radio
body to securely affix the belt clip to the radio.
Install the belt clip at the rear of the battery compartment cover as
shown in the figure provided on the right.
Do not use glue to affix the screws onto the battery clip.
Application of glue may cause damage to the casing of the battery.
http://baofengradio.us
Assembly
Optional
7