Advanced Topics; Using The Menu System; Scanning - Baofeng UV-5RV2+ Operating Manual

For a complete reference on menu items provided on your device please refer to the Main Definitions
section of this manual.
Note: For radios set to Memory Mode (MR) the following menu items will not take effect: STEP, TXP,
W/N, CTCSS, DCS, S-CODE, PTT-ID, BCL, SFT-D, OFFSET, MEM-CH, BAND.

Using the Menu System

Basic Use
Procedure: Using the Menu with Arrow buttons:
1. Press the [MENU] button to enter the menu.
2. Use the [UP] and [DOWN] buttons to navigate between menu items.
3. Once the desired menu items are found, press the [MENU] button again to select.
4. Use the [UP] and [DOWN] buttons to select the desired parameter.
5. When the parameter is selected you want to set for a given menu item, you can press the
[MENU] button to confirm the setting or press the [EXIT] button to reset the item and exit the
menu system.
6. To exit out of the menu at any time, press the [EXIT] button.
Using Shortcuts
Every menu item has a numerical value associated with it. These numbers can be used for direct access
of any given menu item. To see which numerical value is associated with each menu item, refer to
section, Menu Definitions for more details. The top ten most common features are also the top menu
functions. These items are printed on the keypad for easy reference.
Procedure: Using the Menu with shortcuts.
1. Press the [MENU] button to enter the menu.
2. Use the numeric keypad to enter the number of the menu items.
3. To enter the menu item, press the [Menu] button.
4. For entering the desired parameter, the arrow buttons can be used to scroll through options.
You can also use the numerical shortcuts to access specific menu items.
5. When the parameter is selected, use the [MENU] button to confirm the setting. If needed, press
the [EXIT] button to reset the item or to exit the menu system.
6. To exit the menu at any time, press the [EXIT] button.

Scanning

This device features a built-in scanner for VHF and UHF bands. When in Frequency Mode (VFO), the
scanner will scan in steps according to the set frequency. When scanning in Channel Mode (MR) it will
scan the saved channels applied to the radio.
http://baofengradio.us

Advanced Topics

17