Computer Programming - Baofeng UV-5RV2+ Operating Manual

3. Press the [MENU] button to select.
4. Use the [UP] and [DOWN[ buttons to select a memory channel or enter it in directly on the
numeric keypad.
5. Press the [Menu] button to confirm and save.
6. Press [EXIT] to switch to Channel (MR) mode to test a new channel. To name the channel, you
must connect the radio with the Baofeng PC Software.
Duplex Channels
The following instructions assume that a duplex channel has been set up in VFO mode on the upper
display and that VFO mode is still active.
Procedure: Saving (Programming) a Duplex Channel to Memory
1. Press the [MENU] button to enter the menu.
2. Enter [2] [7] on the numeric keypad to get to MEM-CH.
3. Press the [MENU] button to select.
4. Use the [UP] and [DOWN] buttons to select a memory channel or enter it in directly on the
numeric keypad.
5. Press the [MENU] button to confirm.
6. Press the [SCAN] button to activate reverse mode. If this does not work, you can enter the
frequency manually.
7. Enter [2] [7] on the numeric keypad to get to MEM-CH.
8. Press the [MENU] button to select.
9. Use the [UP] and [DOWN] buttons to select a memory channel or enter it in directly on the
numeric keypad.
10. Press the [MENU] button to confirm and save.

Computer Programming

This section assumes that the Baofeng software is installed on your PC.
Attaching the Programming Cable
Ensure that the radio is off before attaching the cable. To attach the cable, uncover the accessory port
behind the rubber flap on the right side of the radio body. Align the connectors and push the cable
inputs in firmly. Attach the USB connector into the computer and start the programming software. Once
the software has loaded successfully, turn on the radio.
Baofeng Software
Note: When first opening the Baofeng programming software, the language may be default to Chinese.
To change the language to English, go to the second rightmost menu. This will open a list of available
languages to select, including English.
http://baofengradio.us 24