Customization; Display; Power-On Message - Baofeng UV-5RV2+ Operating Manual

To send out a 1750Hz tone burst, press the [A/B] button or ([BAND] button on some older
models) while holding down the [PTT] button. This feature also works even when the keypad
lock is enabled on the radio.
This device allows for customization of both the power-on message and the backlight color during the
three states of transmission: (Transmit, Receive, and Standby).

Display

The LCD on the device is backlit by multicolor LEDs, the color of which can be preset from the menu
system into a variety of colors. To change the colors, follow the steps provided below:
Procedure: Changing the Backlight Color
1. Press the [MENU] button to enter the menu.
2. Enter one of the following on the numeric keypad:
a. [2] [9] to change the Standby color
b. [3] [0] to change the receiver color
c. [3] [1] to change the transmit color
3. Press the [MENU] button to select.
4. Use the [UP] and [DOWN] buttons to select the desired color.
5. Press the [MENU] button to confirm and save.
6. Press the [EXIT] button to exit the menu.
*To change how long the backlight stays on, follow these steps:
Procedure: Setting Backlight Time-Out Duration
1. Press the [MENU] button to enter the menu.
2. Enter [6] on the numeric keypad to get to the Backlight Time-Out setting.
3. Press the [MENU] button to select.
4. Use the [UP] and [DOWN] buttons to increase or decrease the amount of time the backlight
stays on.
5. Press the [MENU] button to confirm and save.
6. Press the [EXIT] button to exit the menu.

Power-On Message

http://baofengradio.us

Customization

22