Download Print this page

English - Johnson Pump F5B-19 12 V DC Instruction Manual

Self priming flexible impeller pump

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 6

ENGLISH

Self-priming, flexible impeller pump flange mounted to
DC motor 12/24 V
Typical applications
Bilge pump, fuel oil transfer, deck washing,
fire pump, fresh water pump, etc.
Design features
Body:
Impeller:
Shaft:
Seal:
Connection:
Liquid temp.: Max +80°C
Motor:
The motor is ignition protected according
to ISO 8846 (Small craft - Electrical devices
- Protection against ignition of surrounding
flammable gases).
Type designation
Type
F5B-19, BSP (-1907, NPTF) 12 V
F5B-19, BSP (-1907, NPTF) 24 V
Pressure and capacity data
(based on water at 20°C and at full voltage
of the motor)
Bar
kPa
0
0
0,1
10
0,3
30
0,6
60
0,9
90
1,2
120
1,5
150
Fuse required
6
Bronze
Nitrile
Stainless steel
Mechanical seal
3/4" BSP or NPTF
0.27 kW, 12/24 V DC
Note: Max continuous
operation for motor
1 hour at 1 bar pressure
Part No.
10-24188-1 (-4)
10-24188-2 (-5)
l/min
Ampere draw
(USGPM)
12 V
55.0 (14.5)
23.2 A
53.0 (14.0)
23.8 A
49.4 (13.1)
24.2 A
39.9 (10.5)
25.1 A
30.1 (8.0)
26.2 A
19.3 (5.1)
29.0 A
9.3 (2.5)
29.8 A
50 A
Installation recommendations
Installation
Pump may be mounted in any position
without loss of efficiency; however, it is
suggested that the pump head be down
if vertical mounting is desired. Mount motor
as close as possible to power source to
obtain full voltage. Do not use lower fuses
than those suggested. Note: Before
installation with electrical control systems,
check that equipment to be used is of
sufficient rated capacity to accept ampere
draw of motor. Low voltage will cause
motor to overheat.
Electrical installation
The pump must be installed in accordance
with ISO 10133 (Boats-electrical system–
Extra-low voltage installations for direct
current, DC). The pump must be equipped
with a separate fuse that acts as an overload
circuitbreaker to protect the motor in the
event of e.g. blocked rotation. The fuse
must be of ignition-protected type.
Incorrect fuse size can lead to fire risk.
The motor's terminals and wiring
connections must be incapsulated in the
enclosed rubber covers. See the figure.
24 V
11.9 A
12.2 A
12.8 A
13.3 A
14.0 A
14.7 A
15.3 A
25 A
offered by Busse-Yachtshop.com
ENGLISH

Advertisement

loading

This manual is also suitable for:

F5b-19 24 v dc