Siemens CP 443-5 Extended Manual page 14

3 Installation and Commissioning
Step
3. Configuration
4. PG/PC Attachment
for Configuration
B4-14
Depending on the communication services being used, configuration involves
the following steps:
S
Node initialization
This is necessary in all situations. This assigns a PROFIBUS address
and bus parameters to the PROFIBUS CP.
S
Configuring connections:
This is necessary when using the communication services, S7 functions
and FDL connections (SEND/RECEIVE interface).
S
DP configuration
This is necessary when the DP mode is used.
For details, see /2/, General Part.
You can connect the PG when configuring the CP as follows:
S
via MPI
S
via LAN / PROFIBUS
The CP 443-5 Extended must already have a PROFIBUS address.
For details, see /2/, General Part.
Explanation / Meaning
CP 443-5 Extended for PROFIBUS / Manual Part B4
Release 6/2005
C79000-G8976-C162-06