Toshiba SATELLITE A200 Maintenance Manual page 140

4 Replacement Procedures
Installing the Optical Drive Module
To install a device in the optical drive module bay, follow the steps below and refer to the
figure in the preceding section.
1. Make sure that the expansion memory door is opened and the ODD screw (M2x3, black)
is removed.
2. Slide the device into the optical drive module bay.
3. Use the black M2x3 screw to secure the optical drive module.
4. Install the expansion memory modules as described in the preceding section.
5. Replace the expansion memory module cover.
4-22 Minnesota 10M/10MG Series Maintenance Manual