Toshiba SATELLITE A200 Maintenance Manual page 135

4. Pull out the black Mylar tab to remove the HDD unit.
5. Remove the HDD from the HDD case.
Installing the Main HDD
To install the main HDD, follow these steps and refer to the figures in the preceding section.
1. Seat the HDD in the HDD case and bracket, and secure it with four M3×3 black screws.
2. Insert the HDD unit into the HDD slot.
3. Secure the HDD door with two black M2.5x4 screws.
Installing the Secondary HDD
To install the secondary HDD, follow these steps and refer to the figures in the preceding
section.
1. Seat the secondary HDD in the HDD case and bracket, and secure it with four M3×3
black screws.
2. Insert the secondary HDD unit into the HDD slot on the right.
3. Secure the HDD door with two black M2.5x4 screws.
Minnesota 10M/10MG Series Maintenance Manual
Figure 4-15 Removing the secondary HDD
4 Replacement Procedures
4-17