Operation; Displays; Table 5-1 Online Parameter Descriptions - Honeywell DirectLine DL423 User Manual

5.1 Displays

Overview
The DirectLine® DL423 displays the Online PV Type and Online Temperature. The
table below describes these parameters. Table 5-2 is the Display Navigation
Procedure.
Parameter
Online PV
Online
Temperature
The default display and home position is the Online PV display. It appears when:
 The unit is powered up
 No button presses for 60 seconds
 The Mode button has been pressed during Cell or Temperature calibration
 The Mode button has been pressed during a configuration edit
The PV measurement and display is updated at a rate of 500 ms.
9/11

5. Operation

Table 5-1 Online Parameter Descriptions

The currently selected PV type determines the current online PV
display. Measured PV is displayed with the highest decimal
precision possible with four digits. PV measurement and display is
updated every 500ms.
The Conductivity and Resistivity displays are optionally solution
temperature compensated to 25C according to the currently
selected solution type.
The Concentration and TDS displays are always measured with
solution compensation as determined by the current solution type.
Range: 0.000 to 1999
Measured temperature expressed with fixed tenths decimal
precision.
Temperature displayed in C or F (default = C)
The last selected units become the current units whenever this
display is accessed.
10.0 to 110.0 C
Range:
14.0 to 230.0 F
DirectLine® DL423 Sensor Module User Manual
Description
Operation
21