Chapter 1 About The 8660 Sdm - Nortel 8660 SDM Installing

Chapter 1
About the 8660 SDM
The 8660 Service Delivery Module Firewall 1 (SDM FW1), FW2, and FW4
operate with the 8600 series input/output (I/O) modules in an 8600 series switch
to provide security within a modular configuration.
The 8660 SDM has the following components that can be installed and removed:
•
•
Each firewall module consists of one PrPMC and one disk drive, and is referred to
as a firewall integrated Service Director (iSD). The model name identifies the
number of PrPMCs and disk drives that are included on the 8660 SDM board. For
example, the SDM FW1 has one PrPMC and one disk drive; the SDM FW2 has
two PrPMCs and two hard drives, and so on.
FW4.
Filler panels can also be added or removed to both the Ethernet Routing Switch
8600 chassis and the 8660 SDM. Instructions are included for these procedures.
See
and installing a PrPMC filler panel" on page
Disk drive (see Chapter 3, "Replacing the disk drives," on page
Processor PCI Mezzanine Card (PrPMC) (see
PrPMC," on page 51)
"Removing and installing a chassis filler panel" on page
Chapter 4, "Replacing a
Figure 1 on page 20
65.
Installing the 8660 Service Delivery Module (SDM)
19
43)
shows the SDM
28, and "Removing