Table of Contents
Advertisement
52 Chapter 4 Replacing a PrPMC
Estimated time to replace a PrPMC
The estimated time to remove a PrPMC is 35 minutes.
The estimated time to install a PrPMC is 35 minutes.
Required tools
You require the following tools to replace a PrPMC:
•
•
Removing a PrPMC
217314-B Rev 00
Phillips #0 or #1 screwdriver
3/16-inch nutdriver
Caution: Disk drives must be halted prior to removing an 8660 SDM
from the chassis. Failure to do so can seriously damage the disk drive,
and cause loss of data. Refer to
SDM" on page 43
become operational automatically when the 8660 SDM is re-inserted in
the chassis slot. Refer to the Firewall and Intrusion Sensor User's Guide
for more detailed instructions on halting disk drives.
"Replacing a disk drive on the 8660
for instructions to halt the disk drives. Disk drives will
Advertisement
Table of Contents
