Table of Contents
Advertisement
14.4 Wrap-Up
Once downloading is complete, close the RFU utility, move "CFG" switch #1
back to the "OFF" (left-hand) position to exit "firmware download" mode, and
cycle power momentarily to the unit by either disconnecting the auxiliary power
supply and/or powering down all connected drives or momentarily removing all
drive communication cables from the unit.
When the unit powers up again, it will be running the new application firmware.
If the new firmware version release notes indicated that the configuration file
might need to be reloaded, then do so at this point.
96
Advertisement
Table of Contents
