Table of Contents
Advertisement
12.3.3 Load Points
Main menu selection number 3 allows the retrieval of a predefined configuration
into working memory and the flash file system (see Figure 21). Loading one of
these configurations overwrites the existing point configuration.
The FLN application listed in menu selection 1 loads the predefined
configuration detailed in section 13.6. Menu selection 2 returns the gateway's
configuration to its factory default state.
Figure 21: Loading a Point File
12.3.4 Xmodem Point File
Main menu selection number 4 gives access to the "xmodem" command, which
allows unit configuration files to be transferred between the gateway and a PC.
Whenever unit configuration is completed, it is strongly recommended that a
backup copy of the configuration file be downloaded from the unit to a PC. One
reason for this is in case it becomes necessary to restore a previous
configuration at a later time. Another reason is that it may be desirable to load
multiple units with the same configuration. Configuration files contain all point
and port settings. A downloaded configuration file can be uploaded to any
compatible XLTR-200, allowing the user to clone multiple units with the same
configuration.
Two different variations of the Xmodem protocol are supported (CRC and
Checksum) for those serial communication packages that only support one or
the other. However, some programs can automatically adapt to the user's
41
Advertisement
Table of Contents
