Printed Circuit Board F; Speed Control Slider - Janome SKYLINE S6 Service Manual

CS ring
Setscrew
CS ring
CS ring
Replacing electronic components

Printed circuit board F

Setscrew

Speed control slider

9
NOTE:
Do not disconnect connectors by pulling on cord.
To disconnect the connectors, grasp the connector,
not the cord.
Printed circuit board F
To remove:
1. Remove the front cover (refer to page 5).
2. Disconnect the printed circuit board F connector from
the printed circuit board A (refer to page 8).
3. Remove the CS rings.
4. Remove the setscrews, and the printed circuit board F.
To attach:
Follow the above procedure in reverse.
Speed control slider
To remove:
1. Remove the front cover (refer to page 5).
2. Disconnect the speed control slider connector from the
printed circuit board A (refer to page 8).
3. Remove the 3 CS rings and the speed control slider.
To attach:
Follow the above procedure in reverse.