Toshiba CD332 User Manual page 18

3. Mode Setting
3.1 Input delay setting
The input delay time of the CD332 can be selected either normal or high speed mode.
Refer to section 2.2 for the delay time of each mode.
The input delay setting is made by the jumper plugs provided on the CD332's printed
circuit board. This setting is applied for all 8 input points as a block.
Set these jumper plugs as follows.
Mode
Normal mode
High speed mode
NOTE
14
Change Detect DC Input Module (CD332)
J1 J2
(1) The factory setting is the normal mode.
(2) Use a pair of tweezers to set the jumper plugs.
(3) J9 must be always OFF (open).
CD332 left side
A B
J10
J3 J4 J5 J6
ON (short)
OFF (open)
J9
A B
J11
J1
J2
J3
J4
J5
J6
J7
J8
J7 J8 J9 J10 J11
OFF B side
OFF A side