Table of Contents
Advertisement
Operating the Drill
Note: First, determine which application you will be using the Drill for, and then attach
the appropriate accessory by following the instructions on page 9.
Warning! Always make sure the Switch (11d) is OFF before plugging in the unit.
1.
Plug the Drill into the Transformer and the Transformer into a power outlet as
shown in FIGURES 4 and 5, below.
2.
Make sure your workpiece is secured in a vise or clamp.
3.
Turn on the Switch (11d). See FIGURE 3 on page 9.
4.
After completing your task, turn off the Drill and unplug the unit from the Trans-
former. Unplug the Transformer from the wall outlet.
Transformer
Note: The Transformer is not shown on any of the parts lists or assembly draw-
ings.
SKU 91618
For technical questions, please call 1-800-444-3353.
DRILL OPERATING INSTRUCTIONS
Power Connection For All Three Tools
FIGURE 4
Transformer
FIGURE 5
Close-up of Connection
To Transformer
To Power Outlet
Connect Tool Here
From Tool
Page 10
Advertisement
Table of Contents
