Supervisor Password - Toshiba Satellite Pro S200 User Manual

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password. To set a Supervisor Password,
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe
This utility lets you do the following:
■
Register, delete or change the Supervisor Password.
■
Create or invalidate a Supervisor Password token.
This function in the TOSHIBA Password Utility lets you invalidate only
supervisor tokens or all tokens, including user and supervisor tokens.
■
Specify restrictions for general users.
Starting the computer by password
If you have already registered a password, there are three ways to start the
computer:
■
Insert an SD Card token before you turn on the computer. The
computer will start normally, without displaying a password prompt.
■
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint System
Boot Authentication. If you would not like to swipe your finger or cannot
authenticate the fingerprint for some reasons, push the BACK SPACE
key to skip the fingerprint authentication screen. You can try to swipe
the fingerprint up to five times. If you failed fingerprint authentication
five times, you must enter the password manually to start the computer.
■
Enter the password manually.
The password is necessary only if the computer was Shutdown and
Hibernation in Boot Mode.
It is not needed in Sleep Mode and Restart.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 1,
following message will appear in the screen:
S
2. Enter the Password.
3. Press ENTER.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
User's Manual
Password=
Power and Power-Up Modes
Getting Started. The
6-12