Advertisement
Follow these instructions to connect your USC 5030 for use:
Procedure
Step 1
Install a USC 5310 small cell module into the USC 5030:
a) Align the module connector with the port connector on the back of the USC 5030 and click the module into place.
b) Screw down the thumb screws on the module.
Figure 1: Small Cell Installation into USC 5030
1
Small cell module
Openings for module antennas
2
3
Port connector
Note
If the screws are not tightened, the module will not be recognized and may not operate correctly. Make sure not
to over-tighten the screws; they should be only hand-tightened.
4
10/100 Base-T Ethernet port
Power port for DC power source
5
3
Advertisement
