Input Voltage - Measuring Inputs; Protection; Preparing To Use The Recorder - Fluke 1760 Getting Started Manual

W X Warning
Connect the supply cable of the device only
to sections CAT I, II or III of the supply system
(For details refer to Identifications section)
and the voltage to earth should not exceed
300 V.
Input Voltage – Measuring Inputs
The measurement category (refer to the "Identifications"
section) and the maximum voltage to earth ground from
the sensors must conform to the power supply system.
Refer to "Inscription" and "Technical Specifications"
section.

Protection

IP50

Preparing to Use the Recorder

Before you use the Recorder, carefully inspect the
packaging and contents to ensure that there is no
damage.
Depending on the configuration you ordered,
Flexi-Set probes and voltage sensors may not be
part of the standard equipment. An internal
transient capture option (factory installed only) is
another configuration that is determined at time
of order.
Verify the shipment is complete using the following list:
•
Fluke 1760 Power Quality Analyzer
•
Carrying Bag
•
Flexi-Set probes and voltage sensors
•
1 standard power cord, with set of country-
specific power plugs
•
Getting Started Manual
•
CD-ROM with application software, manuals,
data sheets, and sample data
•
1 crossover Ethernet cable for direct-PC
connection (grey cable with red RJ45 plugs)
•
1 Ethernet cable for network connection (grey
cable)
•
1 null-modem RS232 connection cable (red
cable)
Power Quality Analyzer
Preparing to Use the Recorder
Note
5