Lenovo SE350 Configuration & Installation Manual page 15

Wall-mounted Configuration
This document provides important information for installing and removing the wall-mounted configuration.
Install the wall-mounted configuration
To install the wall-mounted configuration, complete the following steps.
Note: Reserve 500 mm empty space in front of the node so that you can have sufficient space to install and remove the node.
Note: If you are using VESA mount or installing the server on a wall that has 200x200 and 100x100 threaded holes (M4), purchase
suitable M4 screws (and nuts) by yourself first; then, fasten the node sleeve or the power bracket to the VESA or to the wall.
For VESA mount and threaded wall, skip step 1-3 and go to step 5 or step 6 depending on your configuration.
1.
Place the node sleeve or the power adapter bracket on the wall.
2.
Use a pencil to mark the screw positions.
3.
Drill the four holes as marked.

If you are installing the node sleeve without the power adapter bracket, place the node sleeve on the wall and mark the
screw positions as the following illustration.
15