Create An Optical Recovery Discs - Toshiba Satellite P200 Series User Manual

When removing pre-installed drivers / utilities or when installing, you can
setup the respective drivers / utilities from the following folder.
C: \TOSAPINS\***
When Installing TOSHIBA SD Memory Card Format or other SD utilities,
select TOSHIBA SD Memory Utilities from C:\TOSAPINS\.

Create an Optical Recovery Discs

■
Be sure to connect the AC adaptor when you create Recovery Discs.
■
Be sure to close all other software programs except the Recovery Disc
Creator.
■
Do not run software such as screen savers which can put a heavy load
on the CPU.
■
Operate the computer at full power.
■
Do not use power-saving features.
■
Do not write to the disc when the virus check software is running. Wait
for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
■
Do not use utilities, including those intended to enhance hard disk drive
access speed. They may cause unstable operation and damage data.
■
Do not shut down/log off or Sleep/Hibernate while writing or rewriting
the disc.
■
Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains, or cars.
■
Do not use on an unstable surface such as a stand.
A recovery image of the software on your computer is stored on the hard
disk drive, and can be copied to either CD or DVD media by using the
following steps:
1. Select either blank CD or DVD media.
2. The application will allow you to choose from a variety of different media
onto which the recovery image can be copied including CD-R, CD-RW,
DVD-R, DVD-RW, DVD+R and DVD+RW.
Please note that some of the above media may not be compatible with the
optical disc drive installed into your computer. You should therefore verify
the optical drive supports the blank media you have chosen before
proceeding.
3-10
Getting Started
Satellite P200/Satellite Pro P200