Sleep Mode - Toshiba Satellite P200 Series User Manual

■
Make sure the Hard Disk Drive indicators is off. If you turn off the power
while a disk (disks) is being accessed, you can lose data or damage the
disk.
■
Never turn off the power while an application is running. Doing so could
cause loss data.
■
Never turn off the power, disconnect an external storage device or
remove storage media during data read/write. Doing so can cause data
loss.
3. Click Start then click the arrow button (
management buttons (
menu.
4. Turn off any peripheral devices connected to your computer.
Do not turn the computer or peripheral devices back on immediately - wait
a short period to avoid and peripheral damage.

Sleep Mode

If you do have to interrupt your work, you are able to turn off the power
without exiting from your software by placing the computer into Sleep Mode.
In this mode data is maintained in the computer's main memory so that,
when you turn on the power again, you can continue working right where
you left off
■
When the AC adaptor is connected, the computer will go into Sleep
Mode according to the settings in the Power Options.
■
To restore the operation from the computer from Sleep Mode, press the
power button or press any key. Please be aware that this latter action
only works on the internal keyboard if the. Wake-up on Keyboard option
is enabled within the HW Setup utility.
■
If the computer enters Sleep Mode while a network application is active,
the application might not be restored when the computer is next turned
on and the system returns from Sleep Mode.
■
To prevent the computer from automatically entering Sleep Mode,
disable Sleep Mode within the Power Options. However, please be
aware that this configuration will nullify the computer's Energy Star
compliance.
■
Before entering Sleep Mode, be sure to save your data.
■
Do not install or remove a memory module while the computer is in Sleep
Mode. The Computer or the module could be damaged.
■
Do not remove the battery pack while the computer is in Sleep Mode
(unless the computer is connected to an AC power source). Data in
memory will be lost.
Satellite P200/Satellite Pro P200
) located in the power
) and select Shut Down from the
Getting Started
3-5