Disk Drive; Real Time Clock; Fingerprint Sensor - Toshiba Satellite P200 Series User Manual

Disk drive

For information on disk care refer to Chapter 4, Operating Basics.
Problem
Some programs run
correctly, but others do
not
You cannot access the
disk drive

Real Time Clock

Problem
The following message
is displayed on the
LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.

Fingerprint Sensor

Problem
Reading of the
fingerprint was not
successful.
The fingerprint cannot
be read due to injuries to
the finger.
Satellite P200/Satellite Pro P200
Procedure
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration match's your software's needs.
Try another disk. If you can access this disk, the
original disk (not the disk drive) is problem.
If problems persist, contact your dealer.
Procedure
The RTC battery charge has become exhausted,
you should set the date and time in within the
BIOS setup screen through the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Procedure
Please try again using the correct posture. Refer
to Using the Fingerprint Sensor in Chapter 4,
Operating Basics.
Try the recognition process again using another
enrolled finger.
Try the recognition process again using another
enrolled finger.
If fingerprints from all the enrolled fingers cannot
be read, please logon by using the keyboard to
input the password for the time being.
If problems persist, contact your dealer.
Troubleshooting
9-17