Removing The Oven Carriage; Fitting And Removing The Glass Panels - Siemens HE23BC 0 Series Instruction Manual

Removing the oven carriage

The oven carriage can be easily removed to make cleaning the
oven easier. Pull out the oven carriage its full limit. Hold the
carriage on both sides, lift it slightly and remove it. Place it
carefully on a flat surface. The base of the oven contains
delicate components.
After cleaning, the oven door can be refitted by repeating the
procedure in reverse.

Fitting and removing the glass panels

To make cleaning easier, the glass from the oven carriage can
be removed.
Dismantling
Removing the oven carriage.
1.
Remove the top cover of the oven carriage. To do this,
2.
unscrew the right and left-hand side screws (figure A).
Hold the glass in your hands (left and right) and remove
3.
upwards (figure B).
Place these on a cloth with the handle facing downwards.
The inside glass with the hooks should not be removed from
the oven carriage.
In doors with three glass panels, the following step will also be
necessary:
Unscrew the clips from the right and left and remove them
4.
(figure C).
Remove the top glass panel.
Clean the glass panels using a glass cleaning product and a
soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installing
Follow steps 3 to 5 for doors with two glass panels.
Insert the glass panel by tilting it backwards (figure A).
1.
When fitting the glass, ensure that the marking "right above"
at the bottom left-hand side is upside down.
Position and screw the clips to the right and left (figure B).
2.
Insert the glass panel into the carriage support.
3.
Fit and tighten the screws on the cover. If the cover cannot
4.
be screwed into place, check that the glass panel has been
correctly fitted on the support.
Close the oven carriage.
5.
Once the glass panels have been correctly fitted, the oven is
ready to use.
11