Changing The Basic Settings; Care And Cleaning; Cleaning Products; Light - Siemens HE23BC 0 Series Instruction Manual

Changing the basic settings

Your oven has various basic settings. These settings can be
customised to suit your requirements.
Basic setting Selection 1 Selection 2 Selection 3
c1 Clock display always*
c2 Signal duration approx.
upon completion of 10 seconds
a cooking time or
timer period
c3 Waiting time until a approx.
setting is applied 2 seconds
* Factory setting

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.

Cleaning products

To ensure that the different surfaces are not damaged by using
the wrong cleaning product, follow the instructions in the table.
Do not use
Aggressive or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new tea towels thoroughly before use.
Area Cleaning products
Oven front Hot soapy water:
Clean with a dish cloth and dry with a soft
cloth. Do not use glass cleaner or glass
scrapers for cleaning.
Stainless Hot soapy water:
steel Clean with a dish cloth and dry with a soft
cloth. Remove flecks of limescale, grease,
starch and albumin (e.g. egg white) immedi-
ately, as rust can form underneath them.
Special stainless steel cleaning products
suitable for hot surfaces are available from
our after-sales service or from specialist
retailers. Apply a very thin layer of the clean-
ing product with a soft cloth.
10
only with -
the but-
0
ton
approx. approx.
2 minutes* 5 minutes
approx. approx.
5 seconds* 10 seconds
No other time-setting option should have been set.
Press and hold the 0 button for approx. 4 seconds.
1.
The current basic setting for the clock display is shown in the
display, e.g. c1 1 for selection 1.
Use the or button to change the basic setting.
@ A
2.
Confirm by pressing the
3.
The next basic setting appears in the display. You can scroll
through all levels with the
with the @ or A button.
To finish, press and hold the
4.
All basic settings are applied.
You may change the basic settings at any time.
Area Cleaning products
Glass Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Display Glass cleaner:
Clean with a soft cloth. Do not use alcohol,
vinegar, or any other aggressive or abrasive
cleaning agents.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Oven carriage Hot soapy water or a vinegar solution:
floor Clean with a dish cloth.
Cooking com- Hot soapy water or a vinegar solution:
partment Clean with a dish cloth.
Use stainless steel wire wool or oven
cleaner to remove stubborn dirt. Use only
when the cooking compartment is cold.
Glass cover for Hot soapy water:
the oven light Clean with a dish cloth.
Seal (do not Hot soapy water:
remove) Clean with a dish cloth. Do not scrub.
Accessories Hot soapy water:
Soak and clean with a dish cloth or brush.

Light

The oven light can be turned on manually to facilitate cleaning.
Turning on the oven light
Turn the function control knob to the
The light will come on. The temperature control knob must be
turned off.
Turning the oven light off
Turn the function control knob to the
0 button.
button and change the setting
0
button for approx. 4 seconds.
0
\ setting.
Û position.