Omron NS Series Setup Manual page 64

3-6 Using Memory Cards
Note
Back of the PT's case
● Automatic Download
An automatic download transfers system programs and screen data from the Memory Card
to the PT.
Set the DIP switch for automatic download, as shown below.
The Memory Card cannot be used to transfer data when the DIP switch pins are set to com-
binations other than those specified here.
1
ON
OFF
OFF
OFF
Use the following procedure to automatically download data.
1. Turn OFF the power to the PT.
2. Set the DIP switch.
3. Insert the Memory Card with the specified banks stored in it into the PT.
4. Turn ON the power to the PT.
The system programs and screen data will be written to the PT.
5. The status of the PT indicators during data transfer is as shown below.
Do not remove the Memory Card during data transfer.
Transferring data:
Transferring completed:
Error occurred:
Refer to page 3-25 if an error occurs.
6. Turn OFF the power.
7. Remove the Memory Card.
3-22
Use the following technique when changing DIP-switch settings.
Correct technique
The DIP switch may bend or break if the tool is incorrectly levered against the PT's case as
shown in the diagram.
DIP switch pin and status
2 3 4
OFF OFF OFF OFF
ON
OFF OFF OFF
ON
OFF OFF OFF
ON
OFF OFF OFF
DIP switch
5 6
Automatically downloads bank 1 system pro-
grams and screen data.
OFF
Automatically downloads bank 2 system pro-
grams and screen data.
OFF
Automatically downloads bank 3 system pro-
grams and screen data.
OFF
Automatically downloads bank 4 system pro-
grams and screen data.
OFF
Indicator flashes orange.
Indicator flashes green.
Indicator flashes red.
Incorrect technique
Operation