Table of Contents
Advertisement
70/143
Bosch Rexroth AG
Connection
Connect the temperature sensor
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
Fig. 8-6:
Connection total shield with cable extension
4. Cut the soldered cable accordingly and finally assemble the correct ring
terminal with a crimping tool.
Fig. 8-7:
Cut shield extension in a suitable way and assemble the ring ter‐
minal
To protect the motor from thermal overload, the temperature sensor for motor
protection must be connected to the drive controller. Observe the connection
designation under
fig. 8-3 "Connection designation within terminal boxes" on
page 68
and the notes about temperature sensor in the document
Also refer to R911343624 "Rexroth IndraDyn E Standard Motors MOT-FC for
Frequency Converter Operation"
motor data sheet under
chapter 1.2 "Necessary and Supplementary Docu‐
mentation" on page
15.
DOK-SYTROX-MPES2******-IT01-EN-P
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Rexroth Sytronix FcP 50 Series and is the answer not in the manual?