Hitachi CR 18DBL Handling Instructions Manual page 42

English
Mode
Low
Transmisson
Medium
Mode
High
AUTO Mode
NOTE
The mode selector switch can only be set after the battery has been installed in the tool and
the trigger switch has been pulled once.
5. How to use the Hook
The hook can be used to hang up the unit
temporarilyduring operations (Fig. 23, Fig. 24).
CAUTION
The hook should never be used to hang the
uniton your person.
When using the hook, check to make sure that
the main unit will not slip and fall, or become
unstable by the wind, etc.
Never hang the unit from your belt or trousers
as this could cause accidents.
Table 4
State of lamp Operating speed
0 – 1600 /min
0 – 2300 /min
0 – 2500 /min
0 – 1600 /min
2500 /min (When the
load becomes heavier)
42
Uses
Stainless steel
Plastic
Fiber board
Mild steel pipes
Cast-iron tubes
L-shaped angle steel
Aluminum / brass / copper
Plaster board
Wood
CAUTION
Do not cut stainless
steel in Auto Mode.
Hook
Fig. 23
Hook
Fig. 24