Table of Contents
Advertisement
English
CAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach of children and infi rm persons.
PRECAUTIONS FOR CORDLESS RECIPROCATING SAW
1.
Always charge the battery at a temperature of 0 – 40°C.
A temperature of less than 0°C will result in over charging which is dangerous. The
battery cannot be charged at a temperature higher than 40°C.
The most suitable temperature for charging is that of 20 – 25°C.
2.
Do not use the charger continuously.
When one charging is completed, leave the charger for about 15 minutes before
the next charging of battery.
3.
Do not allow foreign matter to enter the hole for connecting the rechargeable
battery.
4.
Never disassemble the rechargeable battery and charger.
5.
Never short-circuit the rechargeable battery. Short-circuiting the battery will cause
a great electric current and overheat. It results in burn or damage to the battery.
6.
Do not dispose of the battery in fi re.
If the battery is burnt, it may explode.
7.
When cutting in wall, fl oor or ceiling, check for buried electric power cord, etc.
8.
Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
9.
Using an exhausted battery will damage the charger.
10. Do not insert object into the air ventilation slots of the charger.
Inserting metal objects or infl ammables into the charger air ventilation slots will
result in electrical shock hazard or damaged charger.
11. When using this unit continuously, the unit may overheat, leading to damage in the
motor and switch. Please leave it without using it for approximately 15 minutes.
12. Wear earplugs to protect your ears during operation.
13. Do not touch the blade during or immediately after operation. The blade becomes
very hot during operation and could cause serious burns.
14. Always hold the body handle and front cover of the power tool fi rmly. Otherwise
the counterforce produced may result in inaccurate and even dangerous operation.
15. Remove the battery from tool or place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tools.
28
Advertisement
Chapters
Table of Contents
