Table of Contents
Advertisement
8. Pins, spacers and plastic spacers
Some display models are supplied with pins, spacers and plastic spacers.
With multiple screens configuration, installing the pins and the spacers makes it possible to secure a constant gap between
the displays.
However, the pins can be installed only on the models that have pin holes of 6 mm in diameter in their bottom and right
sides.
The pins cannot be used with the other models.
Also, the pins, spacers and plastic spacers cannot be used for installation brackets that allow the display to move (Example:
Pantograph mechanisms, slide mechanisms).
Front side
(1) Spacers
The spacers supplied with the display can be installed in the screw holes on the top and left sides of the display.
They are useful to prevent the display from coming into contact on their weaker sides with other displays in multiple
screens configuration. Therefore, we recommend installing these spacers in this configuration.
However, it cannot be used for installation brackets that allow the display to move back and forth or left and right
(Example: Pantograph mechanisms, slide mechanisms).
Spacer
Example: Spacer installation with multiple screens configuration
English - 15
Pin hole
[Installation locations]
Front side
Spacer
Advertisement
Table of Contents
