Manual Priming Of The Water Circuit; Setting The Language And The Clock - Saeco 10002683 Operating And Maintenance Manual

6 INSTALLATION

MANUAL PRIMING OF THE WATER CIRCUIT

Manually prime the water circuit only when display (2) appears.
Note: fi rst make sure that the water tank is full.
Important: before performing the circuit priming, position the SBS system (see page 9) as shown on the
display. Then adjust as desired.
1
Position a container under the hot
water spout (it is possible that
water will not come out of the
spout).

SETTING THE LANGUAGE AND THE CLOCK

When the machine is switched-on for the fi rst time, it requires the selection of the desired language.
This allows you to adjust the parameters of the beverages to the typical parameters of the country
where the machine is used. This is why some languages are differentiated also by country.
1
deutsch
language
english
italiano (ch)
Select the desired language.
4
self-test
demo
The machine starts and displays
the menu in the selected
language.
2
priming the machine
position the SBS system as shown
Press the display once and the
machine will begin priming the
water circuit.
2
français
deutsch
english
ok
Press to select the desired
language.
4
demo
If desired, the "demo" function (see page 28)
may be activated by pressing the key, each time
the machine carries out a self-diagnosis.
start
français
language
italiano (ch)
ok
self-test
3
When the prime circuit cycle is
fi nished, remove the container.
The machine is now ready for
use.
3
deutsch
language
english
Press "ok".
5
See manual on page 36 to
adjust the clock.
français
italiano (ch)
ok