Adjust Image - HIKVISION DS-TCG227-A Series User Manual

User Manual of DS-TCG227-A Series Entrance/Exit Capture Unit
scene mode for the capture unit.
Steps:
1. Go to Setup Wizard > General Configuration.
2. Configure the parameters.
 IP Address, Subnet Mask, Default Gateway: Configure the parameters of
the captured unit.
 Capture Mode: The default capture mode is Strobe Light Mode.
 Scene Mode: Entrance and Exit of Underground Parking Lot, Normal
Entrance and Exit, and Toll Station are selectable.

2.7.2 Adjust Image

Purpose:
You can configure the lane line, right border line, LPR area, and trigger line, draw the
plate recognition area, and adjust the lens on the Image Adjustment page.
Go to Setup Wizard > Image Adjustment. The default LPR area and lines will
display on the image.
Figure 2-5 General Configuration
13