Advertisement
Quick Links
Advertisement
Related Manuals for HIKVISION DS-TCL400-E
Summary of Contents for HIKVISION DS-TCL400-E
- Page 1 Smart On-Street ANPR Camera Quick Start Guide...
- Page 2 WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES,...
-
Page 3: Regulatory Information
English YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE WITH ALL APPLICABLE LAWS, AND YOU ARE SOLELY RESPONSIBLE FOR ENSURING THAT YOUR USE CONFORMS TO THE APPLICABLE LAW. ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS PRODUCT IN A MANNER THAT DOES NOT INFRINGE ON THE RIGHTS OF THIRD PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY, INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION AND OTHER PRIVACY RIGHTS. - Page 4 English EU Conformity Statement This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable harmonized European standards listed under the EMC Directive 2014/30/EU, the LVD Directive 2014/35/EU, the RoHS Directive 2011/65/EU.
- Page 5 English product specification for detailed power requirements. It is recommended to provide independent power adapter for each device as adapter overload may cause over-heating or a fire hazard. Make sure that the power has been disconnected before you wire, install, ...
- Page 6 English DO NOT touch the sharp edges or corners. To prevent possible hearing damage, DO NOT listen at high volume levels for long periods. If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and contact the service center.
-
Page 7: Cable Overview
English Appearance Description Description Status indicator Supplement light Camera Column mount Cable Overview Interface Description Interface Description RS-485 Network interface interface UART Power debugging input interface Warning: The network interfaces are dedicated non-standard PoE network interfaces. You are not allowed to connect them to normal devices to avoid burning the normal devices. - Page 8 English Connect Network Cable Follow the No. on the figure below to connect the network interfaces of the device to the switch via twisted pair. Warning: Incorrect cable order will burn the device and power supply. Color Color Light orange Light blue Orange Green...
-
Page 9: Power Supply Mode
English Description Description Combiner patch Switch cord Power cord (48 Network cable VDC) Power Supply Mode 48 VDC... - Page 10 English 24 VDC Description Description Cabinet (48 VDC/24 The distance between VDC power supply + two devices (L1) 100 M/1000 M switch + combiner cable) The distance between Network cable (< 100 the device and m, 220 VAC) cabinet (L2) 1000 M switch Note: The number of the cascaded devices of each channel depends on L1 and L2.
-
Page 11: Installation
English Description Description PoE interface Combiner patch cord Power connector with Network interface insulating tape Network cable Installation ⑤ ⑥ ⑦... - Page 12 English Description Description M8 expansion bolt T20 wrench Insulating tape M4 nut M4 screw Note: Align the front direction of the camera to the arrow direction on the column mount base. Never place the equipment in an unstable location. The equipment may ...
- Page 13 UD24373B...
Need help?
Do you have a question about the DS-TCL400-E and is the answer not in the manual?
Questions and answers