Display Messages - Saeco 740816308 Operating Instructions Manual

28

DISPLAY MESSAGES

The control panel display guides users and helps them to use the machine correctly.
Descale the machine
Fill the water tank with fresh drinking water.
Load the circuit (Starting up)
Fill the coffee bean container with coffee
beans.
Open the door, remove the dregs drawer
and empty the used coffee grinds into a
suitable container.
Important note: the dregs drawer may
be emptied only when the machine is
on. The drawer must be removed for
at least 5 seconds. If you empty the
drawer with the machine off, you will
not be able to dispense coffee the next
time you switch the machine on.
Fit the brew unit, drip tray and dregs drawer
correctly into place.
Close the front door.
Coffee grinder motor jammed.
Brew unit motor jammed.
Contact an Authorised Service Centre.
PROBLEMS CAUSES
The machine does not The machine
turn on. connected to the power
supply.
The coffee is not hot The cups are cold.
enough.
Only water is No preground coffee has
dispensed when you been introduced.
select "preground
coffee".
No hot water or steam The tube
is dispensed. clogged.
The machine takes a Excessive
long time to warm up. built up.
The brew unit cannot The unit has stopped in
be removed. the wrong position.
REMEDIES
is not Move the main switch to ON.
Check the plug and the
connection
Warm up the cups.
Dispense again
introducing preground coffee.
nozzle is Clean the nozzle opening
with a needle.
During this
ration, the knob must
be closed and the machine
must be off.
scale has Descale the machine.
Close the door and switch on
the machine; the brew unit
will move back into position.
after
ope-