Advertisement
Command
pmsetauto <port> <vpi> <vci> <flags>
pmactivate <port> <vpi> <vci> <flags>
<txblock> <rxblock> <dir>
pmdeactivate <port> <vpi> <vci> <flags>
pmstart <port> <vpi> <vci> <flags> <txblock>
<rxblock> <dir>
pmstop <port> <vpi> <vci> <flags> <dir>
pmstats <port> <vpi> <vci> <flags>
Portcli:
Command
8khzsource [<port> [int|off]]
errors [diff]
help [all|<command>]
portinfo [<port>]
portload [<port>]
portmode <port>|all
uni30|uni31|uni40|iispuser|iispnet|mast|gsmp|ifmp
setportflag <port>|all <portflag>
show <port>
speed <port> [tx default|<cps>][rx default|cps]
stats [diff]
unsetportflag <port>|all <portflag>
version
vport
Ppp:
Command
bcp
clear
disable
discard
echo
2002/9/13
- set up auto accept of activation requests
- send activate request
- send deactivate request
- start transmission/reception of PM cells
- stop transmission/reception of PM cells
- display PM stats
- set source of 8kHz reference signal
- show error counts
- print help information
- show port information
- show port loading
- set port mode (group of flags)
- set port flag
- show detail information for a port
- set port speed
- print statistics
- clear port flag
- show switch CLI version
- add or remove virtual ports
- <channel> bcp stp|nostp: set if BCP uses spanning tree packets
over this channel
- <channel> clear: clear channel to initial state
- <channel> disable: disable PPP on this channel
- <channel> discard [<size>]: send LCP 'discard' packet
- <channel> echo [<size>]: send LCP 'echo' packet
15/18
Description
Description
Description
Advertisement
