Advertisement
Command
trace <util | fault | cc | loopback | all | none >
dl
Oamcli:
Command
config
version
getversion
inf
list
ccglobalaccept
pmglobalaccept
segmentset <port> <vpi> <vci> <flags>
segmentclear <port> <vpi> <vci> <flags>
faultset <port> <vpi> <vci> <flags>
faultclear <port> <vpi> <vci> <flags>
faultwatch <port> <vpi> <vci> <flags>
faultunwatch <port> <vpi> <vci> <flags>
faultbegin <port> <vpi> <vci> <flags>
faultend <port> <vpi> <vci> <flags>
ccset <port> <vpi> <vci> <flags>
ccclear <port> <vpi> <vci> <flags>
ccsetauto <port> <vpi> <vci> <flags>
ccactivate <port> <vpi> <vci> <flags> <dir>
ccdeactivate <port> <vpi> <vci> <flags> <dir>
ccstart <port> <vpi> <vci> <flags> <dir>
ccstop <port> <vpi> <vci> <flags> <dir>
loopset <port> <vpi> <vci> <flags> <llid>
loopclear <port> <vpi> <vci> <flags>
loop <port> <vpi> <vci> <flags> <llid>
loopstats <port> <vpi> <vci> <flags>
pmset <port> <vpi> <vci> <flags>
pmclear <port> <vpi> <vci> <flags>
D-Link Confidential
2002/9/13
- show / set tracing
- dump contents of lookup tables
- display message saying there is no storable configuration
- show oamcli version
- get the oam process version
- get a channels state
- list channels state
- toggle auto acceptance/rejection of CC activate requests
- toggle auto acceptance/rejection of PM activate requests
- set up a segment sink point
- remove a segment sink point
- turn fault management on
- turn fault management off
- turn fault monitoring on
- turn fault monitoring off
- declare a fault state
- clear a fault state
- set up reception of activation requests
- clear reception of activation requests
- set up auto accept of activation requests
- send activate request
- send deactivate request
- start transmission/reception of CC cells
- stop transmission/reception of CC cells
- enable loopback
- disable loopback
- send a loopback cell
- display loopback stats
- set up reception of activation requests
- clear reception of activation requests
14/18
Description
Description
Advertisement
