Huawei SUN2000-175KTL-H0 User Manual page 71

SUN2000-(175KTL-H0, 185KTL-INH0, 185KTL-H1)
User Manual
No. Parameters
3 Maximum active
power
Shutdown at 0%
4
power limit
5 Active power change
gradient
6 Fixed active power
derating
7 Active power
percentage derating
8 Reactive power
output at night
Enable reactive
9
power parameters at
night
10 Reactive power
compensation at
night
11 Reactive power
change gradient
12 Plant active power
gradient
13 Filter duration for
average active power
14 Power factor
15 Reactive power
compensation(Q/S)
Issue 02 (2019-06-05)
Description
Sets the upper threshold for the active
power output to adapt to different
market requirements.
If this parameter is set to Enable, the
SUN2000 shuts down after receiving
the 0% power limit command. If this
parameter is set to Disable, the
SUN2000 does not shut down after
receiving the 0% power limit
command.
Adjusts the change speed of the
inverter active power.
Adjusts the active power output of the
inverter by fixed value.
Adjusts the active power output of the
inverter by percentage.
In some specific application scenarios,
a power grid company requires that the
inverter can perform reactive power
compensation at night to ensure that
the power factor of the local power
grid meets requirements.
When this parameter is set to Enable,
the inverter outputs reactive power
based on the setting of Reactive
power compensation at night.
Otherwise, the inverter executes the
remote scheduling command.
During the reactive power
compensation at night, the reactive
power is scheduled by fixed value
Specifies the change speed of the
inverter reactive power.
Specifies the rate of active power rise
due to sunlight changes.
Specifies the period of active power
rise due to sunlight changes. This
parameter is used with Plant active
power gradient.
Adjusts the inverter power factor.
Specifies the reactive power output by
the inverter.
Copyright © Huawei Technologies Co., Ltd.
7 Man-Machine Interactions
Remarks
-
-
Adjust the change speed
according to the percentage of
the rated apparent power.
-
If this parameter is set to 100,
the inverter outputs power based
on the maximum output power.
-
This parameter is displayed
when Reactive power output at
night is set to Enable.
This parameter is displayed
when Reactive power output at
night is set to Enable.
-
-
-
-
-
65