Table of Contents
Advertisement
D.
Hooking Up Your
TV/VCR to Another
Video Source
(VCR or Camcorder)
You may need this connection
if you want to copy tapes.
Details are on page 31.
AUDIO/VIDEO OUT
Jacks on VCR
3CH
IN
4CH
AUDIO
VIDEO
ANT.
OUT
OUT
IN
2
Plug in the TV/VCR's power cord.
3
Before you turn on the TV/VCR, go to page eight.
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is
bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
• A rod antenna (not supplied) is available from Philips Service Solutions Group. The part number is 4835 303
37006. To order, call 1-800-851-8885. (This antenna will fit the CC13B1MG only.)
• Audio and video cables are not supplied.
Crooked Pin
Cable
Use an Audio cable to connect the AUDIO
OUT Jack on the VCR to the AUDIO In Jack
on the front of the TV/VCR.
3CH
IN
4CH
AUDIO
VIDEO
ANT.
OUT
OUT
IN
Use a Video cable to connect the VIDEO OUT Jack on the
VCR to the VIDEO In Jack on the front of the TV/VCR.
Helpful Hints
Bent pin
Plug
Hooking Up the TV/VCR (cont'd) 7
AUDIO
VIDEO
Straight Pin
AUDIO VIDEO
STOP
REW
PLAY
F.FWD
REC
CHANNEL
VOLUME
POWER
EJECT
OTR
EARPHONE
AUDIO/VIDEO In Jacks
on front of TV/VCR
Advertisement
Table of Contents
