Raleigh Audio Standard Extreme RAKK dac Mark III Assembly Manual page 46

Wire the RAKK dac Inputs
9. If you have chosen to have an SPDIF or AES/EBU Input 1, connect the violet/black twisted
pair from that jack to the Input 1 pads on the RAKK dac. Connect the violet wire to the "+"
pad and the black wire to the "-" pad.
10. If you have chosen to have an SPDIF or AES/EBU Input 2, connect the violet/black twisted
pair from that jack to the Input 2 pads on the RAKK dac. Connect the violet wire to the "+"
pad and the black wire to the "-" pad.
11. If you have chosen to have an SPDIF or AES/EBU Input 3, connect the violet/black twisted
pair from that jack to the Input 3 pads on the RAKK dac. Connect the violet wire to the "+"
pad and the black wire to the "-" pad.
12. If you have chosen to have a TOSLINK, connect the 19" red/black twisted pair from the 10V
Regulator to the 12V pads on the TOSLINK board. Connect the red wire to the + pad and the
black wire to the – pad.
————————————————————————————
Connect the I2S Inputs
Skip this step if you do not have an I2S Adapter
13. Connect the flat cables to the appropriate inputs on the I2S Adapter.
————————————————————————————
Wire the USB Adapter and connect it to the I2S Adapter
Skip this section if you do not have a USB Adapter.
Skip this step if you do not have an I2S Adapter.
14. Locate the red/black twisted pair from the 8V Regulator and connect it to the 8V pads on the
USB Adapter. Connect the red wire to the "+" pad and the black wire to the "-" pad.
15. Connect the flat cable to the appropriate input on the I2S Adapter.
————————————————————————————
45