Pre-Assemble (Three-Input) I2S Adapter With The Rakk Dac - Raleigh Audio Standard Extreme RAKK dac Mark III Assembly Manual

Pre­assemble (three­input) I2S Adapter with the RAKK dac
————————————————————————————
Skip this section if you do not have a (three-input) I2S Adapter.
————————————————————————————
Wire the I2S Output on the small adapter board
The three-input I2S adapter has a connector on its I2S output. This connector will plug into a
small adapter board, which in turn will be soldered onto the RAKK dac.
1. Connect a 1" (male/female) standoff together with a ⅜" standoff.
This may be used as a gauge for cutting the following wires.
2. Cut three pieces of #22 black wire, each 1⅜" long.
3. Cut three pieces of #22 violet wire, each 1⅜" long.
4. Strip ¼" of insulation from each end of the wires and tin the ends by melting a little solder
onto the stripped ends.
9