Raleigh Audio Standard Extreme RAKK dac Mark III Assembly Manual page 33

Mount the 12V Power Supply board
31. Dress the red/black twisted pairs from the 10V and 5V Regulators directly to the Active
Output and then towards the front of the panel.
♪
32. Place the Power Supply board in its location between the Active Output board and the
transformer. Orient the board such that the 12VDC Output is towards the back of the panel.
Do not secure the board yet.
33. Dress the attached wires as follows:
• Dress the red/black twisted pair from the 12V DC output under the Active Output directly
towards the left side of the chassis.
• Dress the green wire directly towards the back of the panel.
• Dress the violet/white twisted pair from the "LED" pads under the board and out toward
the front of the panel. This should be to the left of the white/black twisted pairs.
• Dress the short white/black twisted pair out the front and directly to the right in front of
the power transformer.
• Dress the white/black "T" power cable directly towards the front of the panel.
34. Connect the short white/black twisted pair to the power transformer.
• Connect the black wire to pin 2.
• Connect the white wire to pin 10.
32