Table of Contents
Advertisement
Panel Preparation
Cut one 10" x 2" piece of damping material into two pieces: 10" x 1".
Cut another 10" x 2" piece of damping material into three pieces:
Two, 8" x 1" and one, 2" x 2".
Cut the remaining 10" x 2" piece of damping material into four pieces:
Two, 4" x 1", one, 8" x 1" and one, 2" x 2".
————————————————————————————
Bottom Panel Preparation
Note that the lip on the bottom panel points towards the inside.
1. Install the four feet in their holes close to the corners of the panel.
Use a 6-32 x ½" screw, flat washer and Kep nut on each foot.
Place the washer between the head of the screw and the rubber foot.
Install one piece of 8" x 1" damping material on the inside of the bottom panel, centered
2.
between the vents and the lip.
Install one piece of 4" x 1" damping material on the inside of the bottom panel, next to and
3.
centered on the left side of the vents.
Install one piece of 4" x 1" damping material on the inside of the bottom panel, about 1"
4.
away from and centered on the right side of the vents.
Note that the bottom panel in the picture above has lines drawn to show where the transformer
and circuit boards will be mounted.
23
Advertisement
Table of Contents
