Timer Recording With The Vcr Plus+ Programming System - Philips VR960BPH Owner's Manual

38 Timer Recording with the VCR Plus+ Programming System

Follow the steps below to program a timer recording using
PlusCode programming numbers. Before you begin make sure:
• Channels are set up. Details are on pages 12-13.
• The clock is set. Details are on pages 14-18.
• There is a tape in the VCR. Make sure the tape's record tab is
intact and the tape is long enough to record the program(s).
• The VCR is in VCR position (the VCR light will appear on the
display panel). If the VCR light does not appear, press the
VCR/TV button once.
• You have programmed the VCR Plus+ and Cable/TV channel
numbers. Details are on pages 36-37.
Complete each step within 60 seconds of completing the
previous step. If you don't, you may start again at step 1.
1
Press the VCR button.
2
Press the TIMER button.
VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
SELECT: ,9
CONFIRM: OK
END: TIMER
3
Press the PLAY 8 or STOP 9 button to select VCR
PLUS+, then press the OK/STATUS button.
VCR PLUS+ PROG. CODE
L
VCR PLUS+
END: TIMER
4
Use the Number buttons to enter the PlusCode
programming number of the program you wish to record.
(This number is different for every program.)
VCR PLUS+ PROG. CODE
VCR PLUS+ 123L
CONFIRM: OK
CORRECT: CLEAR
END: TIMER
CBL / DBS TV VCR
VCR/TV POWER SMARTPICTURE
QUICK PROGRAMMING
+ +
1 2 3
START STOP DATE
4 - 5 - 6
DAILY WEEKLY
7 8 9
SPEED DBS
0
ALT CLEAR
STILL/SLOW
- +
REW
PLAY
STOP
VOL CH
OK/STATUS
MENU
TIMER
TURBO AUDIO/ SKIP REC END
SEARCH SEARCH
TIMER MUTE
REC REC
EJECT
Helpful Hint
• If you enter an incorrect PlusCode
programming number at step 4,
ERROR-RE-ENTER CODE will flash on
the screen after step 5. Enter the
correct PlusCode programming
number.
1
4
FF
3
2
/OTR