Table of Contents
Advertisement
34 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
Channels are programmed (page 12).
The VCR Plus+ and Cable/TV channel numbers are entered
(pages 32-33).
The clock is set (page 15).
There is a tape in the VCR. Make sure the tape's record tab is
intact and the tape is long enough to record the program(s).
The VCR light appears on the display panel of the VCR. If it
does not, press the VCR/TV button once.
Complete each step within 60 seconds of completing the
previous step. If you don't, you may return to step 1.
1
Press the VCR PLUS+ button on the remote control. The on-
screen display shown below will appear.
VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
2
Use the Number buttons to enter the PlusCode program-
ming number of the program you wish to record (this number is
different for every program, and it can be four to eight digits long).
Finally, press the VCR PLUS+ button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR +
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
3
To record the program once, press the Number 1 button to
select ONCE. To record the same program every day from
Monday through Friday, press the Number 2 button to select
DAILY. To record the same program every week on the same
day (such as every Saturday), press the Number 3 button to
select WEEKLY.
VCR PLUS+ PROG.
1 ONCE
2 DAILY
3 WEEKLY
TO SELECT PUSH NO. SHOWN
TO END PUSH EXIT
3
2
2
3
1
5
6
4
8
9
7
1
0
+100
PLAY
REW
F.FWD
STOP
Helpful Hints
• ALL PROGRAMS IN USE will appear
on-screen at step 1 if all timer
recording slots are full. See page 31
to clear a timer recording slot.
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR PLUS+
button, the number you entered was
incorrect or too short. If this hap-
pens, enter the correct number.
• CLASH may flash on the screen at
step 2 or at step 5. This means that
the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out.
• If the end of the tape is reached
during a timer recording, recording
will stop. The VCR will eject the tape
and turn itself off.
Advertisement
Table of Contents
