Table of Contents
Advertisement
VRZ242 LAYOUT
4/9/99 9:25 AM
36 Timer Recording With the VCR Plus+ Programming System
Follow these steps to set a timer recording with the PlusCode
programming numbers in your TV guide. Before you begin:
Set up the channels at the VCR (page 12).
Set up the VCR Plus+ and Cable/TV channel numbers (pages 34
- 35).
Set the clock (page 15).
Put a tape in the VCR.
Turn on the VCR power. The VCR light should appear on the
display panel. If it does not, press the VCR/TV button once.
Do each step within 60 seconds of the previous step.
1
Press the VCR button.
2
Press the VCR PLUS+ /ENTER button.
VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
3
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record.
Then, press the VCR PLUS+ /ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR+
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
Press the PLAY/o button or the STOP/p button to select
a ONCE, DAILY, OR WEEKLY recording. Then, press the
F.FWD/B button.
ONCE: The VCR will record a TV program on any day you
choose, up to 12 months away.
DAILY: The VCR will record every day from Monday to Friday
– starting at the same time and recording for the same length of
time.
WEEKLY: The VCR will record on the same day, at the same
time, and for the same length of time every week.
VCR PLUS+ PROG.
ONCE
DAILY
WEEKLY
SELECT op CHOOSE B
TO END PUSH EXIT
Page 36
1
2
3
1
5
6
4
8
9
7
2
0
+100
4
PLAY
REW
F.FWD
STOP
Helpful Hints
• CODE ERROR may flash on-screen
after step 3 if you enter an incorrect
number (for example, one that is too
short). The previous screen will
appear. Enter the correct PlusCode
programming number.
• If the VCR PLUS+ CROSS REF. MAP
reappears after step 3, the VCR
PLUS + channel number for the
recording you entered was higher
than 99. In this case, enter the cor-
rect CABLE/TV channel in the map.
Then, press the MENU button and
continue from step 4.
• If CLASH flashes on-screen at step
3, the timer recording you just pro-
grammed and another timer record-
ing overlap. The current timer record-
ing will not occur.
3
Advertisement
Table of Contents
