Santec E-Series Instruction Booklet page 3

T r i m
TRIM PLATE & PLATE COVER
- Fit sleeve onto valve until it bottoms out.
- Place foam strip around the inner edge of the shower plate.
- Press the shower plate against the wall.
- Screw the 2 plate screws through the plate holes and onto the
valve's screw holes. Tighten both screws rmly.
- Fit the plate cover over the sleeve and press it all the way into
the trim plate.
HANDLE
- Insert the handle onto the valve stem. Turn the handle
clockwise until it reaches the end. Reposition the handle to
the desired position. The handle should be facing up at 12
o'clock position.
- Using the provided Allen key, insert the set screw onto the
handle and press against the valve's stem Tighten rmly.
- Adjust the height of the handle if it is scraping against the
shower plate.
- Insert the plug into the handle set screw hole.
C OLD
WARM
WARMER
HOT
0 3
Finished wall
Trim plate
Sleeve
Plate screws
Plate cover
Plug
Set screw
Handle
Trim plate
Allen key