Table of Contents
Advertisement
When unpacking, check to make sure all the parts shown on the Parts List on page 12
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
For additional information regarding the parts listed in the
following pages, refer to the Assembly Diagram on page 12.
WARNING! Always make sure the Water Pump (4) is disconnected from its
electrical outlet prior to assembling the Fountain, adding any water, or performing
service to the product.
Assembly Instructions:
1.
Set the Statue (1) into the Bowl (3), making sure to route the Hose (2) into the
Bowl. (See Assy. Diagram.)
2.
Set the Water Pump (4) at the bottom of the Bowl (3). (See Assy. Diagram.)
3.
Connect the Hose (2) to the Connector Tube (5) on the Water Pump (4).
(See Assy. Diagram.)
4.
Fill the Bowl (3) with a minimum 2" of water. Do not overfill the Bowl.
(See Figure F, next page.)
SKU 93455
For technical questions, please call 1-800-444-3353.
SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
V ~
Volts Alternating Current
A
Amperes
No Load Revolutions
no
xxxx/min.
per Minute (RPM)
UNPACKING
Some assembly is required, as shown below.
NOTE:
FIGURE E
Page 9
Advertisement
Table of Contents
