Table of Contents
Advertisement
3.
Maintain a safe environment. Keep the area well lit. Make sure there is
adequate surrounding space. Always keep the area free of obstructions, grease,
oil, trash, and other debris. Do not use an electrically powered product in areas
near flammable chemicals, dusts, and vapors.
4.
Carefully inspect the condition of the Fountain before use, and check the
Fountain periodically during use. If any damage is noted, stop immediately and
repair or replace the Fountain.
5.
Make sure the Water Pump (4) is unplugged from its electrical outlet prior to
performing any inspection, maintenance, or cleaning procedures.
6.
CAUTION! Excessive weight or pressure on any of the Fountain sections
may cause it to tip and/or fall. Keep children and pets away from any of the Foun-
tain sections and the Power Cord.
7.
Use the Water Pump (4) with cold, distilled water only. Mineral buildup from
tap water, or water from other sources, can ruin the Water Pump.
8.
Make sure the water supply used for the Fountain is not dirty, sandy, and
does not contain any corrosive chemical products. Change the water when
necessary and rinse out the Bowl (3).
9.
Running the Water Pump (4) without sufficient water can damage the Pump.
This Pump requires a minimum of 2 inches of water at all times.
10.
If locating the Fountain on a table, make sure the table is flat, level, dry, and
sturdy enough to support the weight of the Fountain and its water.
11.
Avoid accidental electric shock. Keep all electrically powered products
away from the Fountain. Disconnect the Water Pump (4) from its electrical
outlet before placing hands in the Bowl (3) filled with water. Make sure to
stand on a dry, insulated surface such as a rubber mat while using the
Fountain.
13.
Always arrange a "drip loop" in the Power Cord connecting the Water Pump
(4) to a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power
Cord below the level of the electrical outlet (or the connector if an extension cord
is used) to prevent water traveling along the Power Cord and coming in contact
with the outlet. If the Power Cord Plug or outlet does get wet, do not unplug the
Power Cord Plug. Disconnect the fuse or circuit breaker that supplies power to
the electrical outlet. Then, unplug the Power Cord and examine for presence of
water in the outlet. (See Figure A.)
SKU 93455
For technical questions, please call 1-800-444-3353.
Page 5
Advertisement
Table of Contents
