Table of Contents
Advertisement
HOSE (2)
CONNECTOR TUBE (5)
WATER PUMP (4)
Operating Instructions:
CAUTION: Make sure your hands and feet as well as the Transformer (8), are dry, before
plugging in the Transformer.
1.
Plug the Transformer (8) into the nearest 120 volt, grounded, electrical outlet,
making sure to arrange a "drip loop" in the Transformer's Power Cord. The Water
Pump (4) will now run continuously until it is unplugged from its electrical outlet.
(See Figure A.)
2.
Allow sufficient time for the Water Pump (4) to move water upward into the top of
the Statue (1). Once the Statue is filled with water, the water will begin cascading
downward into the Bowl (3) where it will again be pumped upward to repeat
the process. (See Assy. Diagram.)
3.
When finished using the Fountain, always unplug the Transformer (8) from the
electrical outlet. Drain the Fountain of all water. Then store the unit in a clean,
dry, safe location out of reach of children.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure the Transformer (8) is disconnected from its electrical
outlet prior to performing any inspection, maintenance, or cleaning procedures.
SKU 93455
For technical questions, please call 1-800-444-3353.
2" MINIMUM WATER LEVEL
FOR BEST RESULTS,
COMPLETELY SUBMERGE THE
WATER PUMP.
FIGURE F
Page 10
Advertisement
Table of Contents
